PDA

View Full Version : Are These Results Ok

xspeedyx
06-07-2007, 10:48
Downstream Value
Frequency 339000000 Hz Locked
Signal to Noise Ratio 39 dB
Power Level 2 dB The Downstream Power Level reading is a snapshot taken at the time this page was requested. Please Reload/Refresh this Page for a new reading



Upstream Value
Channel ID 1
Frequency 29200000 Hz Ranged

Power Level 55 dBmV

My power never been this low are these ok for 10mb connection?
fatassmichael
06-07-2007, 11:33
darth, your upstream power level looks like its borderline, are you having any probs with disconnects? if all is working, ie, not disconnecting, then i would say it is fine.
xspeedyx
06-07-2007, 12:33
Bout twice a month its discs but I was just wondering why I dont get my full speed anymore after my wireless router has been installed everything is correct I got a netgear 54mbp netgear adaptor
fatassmichael
06-07-2007, 12:51
What speeds are you getting? Check your NIC and see if it has an option to set to full duplex, or auto detect. Maybe your area is being upgraded for 20meg? Is your router and wifi adaptor working in 801.11g mode?
xspeedyx
06-07-2007, 14:19
What speeds are you getting? Check your NIC and see if it has an option to set to full duplex, or auto detect. Maybe your area is being upgraded for 20meg? Is your router and wifi adaptor working in 801.11g mode?

NIC aint connected as I got my wireless I think I know on the settings for the router I am using g and b
fatassmichael
06-07-2007, 15:08
Darth, goto openoffice.org and download the setup, see if you get full speed, that mirror should max out your connection (or get somewhere very close). If you still have speed issues try a wired connection to your modem and/or router and try again.
xspeedyx
06-07-2007, 15:33
seems ok I used utorrent and I got bout 950KB/s on my wireless network
fatassmichael
06-07-2007, 16:05
have you tried connecting through wires? just to rule out any problems with wireless.
Edit, Which router have you got?
Edit to the edit, your upstream frequency is "Ranged" AFAIK that should be "Locked", i'm not sure if that would be affecting anything? Maybe a call to your collegues in faults is in order.