[Chrysalis]

Hmmm

I have managed to flash it to the 2nd firmware, can access the gui fine.

However when I have the cable modem plugged into it, it does not pickup the wan ip and I have no internet access. I plug the cable modem back into the pc and the pc picks up the wan ip fine.

In the setup page I have the wan config set to automatic dhcp configuration which the help slider on the right says is correct for cable isp's.

any ideas?

---------- Post added at 05:16 ---------- Previous post was at 04:00 ----------

Ok I got the net working, I had to clone my pc mac on the router.

If I upgrade to this 14311 version do I just upgrade as normal or do I need to reset all my settings first?

thanks